Хімічний анкер поліефірний Teknobond 401 P (410мл).

Teknobond 401 P is a two-component thixotropic quick-drying chemical anchor based on polyester resin.

Areas of application:

For installing reinforcement and connecting rods
For fastening in concrete, hollow and solid brick
For installing pipes and plumbing in central heating, ventilation, etc.
For anchor bolts and pins
For fixing injection packers
For gluing all types of building materials
Properties of the chemical anchor:

Fast-hardening
Easy to use
Paste-like
Does not slip from any types of surfaces
Prevents the development of reinforcement corrosion
Has high resistance to chemicals
Instructions:

Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting using compressed air.
Concrete substrates must be clean, solid and have sufficient adhesion.
Using a hammer drill, drill a hole of the required diameter and depth. The diameter and depth of the hole must correspond to the size of the anchor element used. The hole must be cleaned of dust and dirt with a round wire brush and compressed air. Then squeeze the trigger and hold until the two separate components of the cartridge come out of the static mixer tip together. Slowly pull the cartridge out, filling the hole. Make sure there are no air gaps inside.
In deep holes, you can use an extension cord. When inserting the anchor, it must be rotated. Then place the anchor element in the hole. Do not move or load the anchor element during hardening.
To open the cover, turn it. Then install the static mixer tip. Place the cartridge in the gun and start applying.
When stopping the application process, the static mixer tip can be left on the cartridge after the pressure has been released.
If the resin in the static mixer has hardened, a new insert must be installed before starting work.
Notes:

Use anchor plugs to secure the anchor material to hollow materials (bricks or blocks).
When storing an open cartridge, remove the static mixer, wipe the cartridge neck with a clean, dry cloth and close the lid.
Contains styrene.
Flammable.
Harmful if inhaled
The product may cause irritation if it comes into contact with the skin and eyes. Work clothes, protective gloves, a mask and goggles must be worn. In case of contact with eyes, rinse the eyes immediately with warm water and seek medical advice.
Keep out of reach of children
Use in well-ventilated areas
Use tools and equipment immediately after use.
Characteristics

Packaging 410 ml cartridge
Shelf life 12 months in closed original packaging
Pot life 7-10 minutes (at 20 °C)
Complete drying 7 days
Re-application time 1 hour (at 20 °C)
Application temperature 0 °C - + 80 °C
Compressive strength 60-70 N/mm2
Adhesion (to concrete surface) ≥ 4 N/mm2
Bending strength 18-20 N/mm2
Pull-out strength ≤ 0.6 mm (under 75 kN load)
Tensile strength ≤ 0.6 mm (under 50 kN load after 3 months)
Standard According to TS EN 1504-6