Chemical anchor Teknobond 400 P(Текнобонд 400 P)

• Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting by using compressed air.
• Concrete bases must be clean, strong and have sufficient adhesion.
• Using a puncher, you should drill a hole of the required diameter and depth. The diameter and depth of the hole must correspond to the size of the anchor element used. The hole should be cleaned with a round wire brush and compressed air from dust and dirt. Then squeeze the trigger and hold it until the two separate components of the cartridge together come out of the tip of the static mixer. Slowly pull out the cartridge, filling the hole. Make sure that there are no air gaps inside.
• An extension cord can be used in deep holes. When inserting the anchor, it is necessary to scroll it. Next, an anchor element should be placed in the hole. The anchor element must not be moved or loaded during curing.
• To open the lid, turn it. Then install the tip of the static mixer. Place the cartridge in the gun and start applying.
• If the application process is stopped, the tip of the static mixer can be left on the cartridge after the pressure is released.
• If the resin has hardened in the static mixer, a new insert must be installed before starting work.

Notes:

• Use anchor dowels to fix the anchor material to hollow materials (bricks or blocks). 
• When storing an open cartridge, remove the static mixer, wipe the cartridge neck with a clean, dry cloth and close the lid.
• Contains styrene.
• Combustible.
• Harmful to health if inhaled
• The product may cause irritation in contact with the skin and eyes. It is necessary to use work clothes, protective gloves, a mask and glasses. In case of contact with the eyes, immediately rinse the eyes with warm water and consult a doctor.
• Keep out of reach of children
• Use in well-ventilated areas
• The tools and equipment used must be cleaned immediately after use.

1. What is a chemical anchor?

Chemical anchor is a two-component fast-hardening thixotropic compound, which is considered one of the most durable and popular materials for fixing fasteners. 

2. How to use a chemical anchor correctly?

Drill and clean the hole of the required diameter and depth, then fix the cartridge in the gun. It is recommended not to use the first 10 cm of the material, since the 2 components of the chemical anchor should mix well. Slowly fill the hole, leaving no air gaps. After that, insert the anchor element into the hole by scrolling movements.

3. What are the chemical anchors?

Chemical anchors are of two types: based on polyester resin and based on epoxyacrylate resin.

4. Where is the chemical anchor used?

Chemical anchor is used for fastening and strong fixation of metal elements during construction and repair.