Decorative coating made of natural stones always looks luxurious. But surface preparation and laying of the material usually takes longer, compared with simpler decorative materials.
Also an important point is the choice of a high-quality adhesive composition, since it is not desirable to use the same material for ordinary ceramic tiles of small sizes, and for heavy marble and granite slabs.
In our article we offer you to get acquainted with the high-quality glue Teknofay EX C2TE, which is designed specifically for laying expensive heavy decorative materials.
Why is it so important to choose a glue for laying marble and granite of higher quality?
Due to the choice of poor-quality or unsuitable adhesive composition, marble or granite slabs may eventually peel off, move out and undergo other changes.
What characteristics should the glue for marble and granite have?
The adhesive for both marble and granite must have high adhesive properties for maximum fixation in both horizontal and vertical positions.
Also, the material should provide the most convenient installation for craftsmen, since it is quite difficult and labor-intensive to work with this type of decorative material, especially when laying it on walls. Therefore, the glue should not slide down, providing convenient laying of marble and granite slabs.
And, of course, the material must be waterproof.
Technical characteristics of Teknofay EX C2TE glue
Among the main technical characteristics of high-quality Teknofay EX C2TE glue are:
- High strength;
- High adhesion: more than 1.0 N/mm2;
- High resistance to sliding: up to 0.5 mm maximum;
It is also important to note that the material is frost-resistant, so it can be used for laying marble and granite in cold rooms, and the material also has a wide range of thermal stability (from -40 ° C to + 80 ° C), which significantly expands the scope of its application.
You can purchase Teknofay EX C2TE glue by phone number: 067 486 42 41.
