Chemical anchor polyester Teknobond 401 P (410 ml).

Teknobond 401 P is a two-component thixotropic quick-drying chemical anchor based on polyester resin.

Areas of application:

• For installing reinforcement and connecting rods
• For fastening in concrete, hollow and solid brick
• For installing pipes and plumbing in central heating, ventilation, etc.
• For anchor bolts and pins
• For fixing injection packers
• For gluing all types of building materials
• Properties of the chemical anchor:

Fast-hardening

• Easy to use
• Paste-like
• Does not slip from any types of surfaces
• Prevents the development of reinforcement corrosion
• Has high resistance to chemicals

Instructions:

Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting using compressed air.
Concrete substrates must be clean, solid and have sufficient adhesion.
Using a hammer drill, drill a hole of the required diameter and depth. The diameter and depth of the hole must correspond to the size of the anchor element used. The hole must be cleaned of dust and dirt with a round wire brush and compressed air. Then squeeze the trigger and hold until the two separate components of the cartridge come out of the static mixer tip together. Slowly pull the cartridge out, filling the hole. Make sure there are no air gaps inside.
In deep holes, you can use an extension cord. When inserting the anchor, it must be rotated. Then place the anchor element in the hole. Do not move or load the anchor element during hardening.
To open the cover, turn it. Then install the static mixer tip. Place the cartridge in the gun and start applying.
When stopping the application process, the static mixer tip can be left on the cartridge after the pressure has been released.
If the resin in the static mixer has hardened, a new insert must be installed before starting work.

Notes:

Use anchor plugs to secure the anchor material to hollow materials (bricks or blocks).
When storing an open cartridge, remove the static mixer, wipe the cartridge neck with a clean, dry cloth and close the lid.
Contains styrene.
Flammable.
Harmful if inhaled
The product may cause irritation if it comes into contact with the skin and eyes. Work clothes, protective gloves, a mask and goggles must be worn. In case of contact with eyes, rinse the eyes immediately with warm water and seek medical advice.
Keep out of reach of children
Use in well-ventilated areas
Use tools and equipment immediately after use.

Characteristics