Excessive exposure to moisture is harmful even for the most durable materials and structures, including concrete, steel reinforcement and other building elements. Therefore, various methods of waterproofing are widely used for the arrangement of baths, including small private buildings. Today we will talk about how to make high-quality insulation of the concrete floor in the bath, and also touch on the issue of preserving the walls from excessive humidity.
How to make waterproofing of a concrete floor in a bath?
For high-quality insulation of concrete floors in modern construction, elastic two-component mixtures are widely used, for example, Teknomer 200 EX Crystallized. The mixture consists of a cement-based powder and a liquid component based on an emulsion polymer and substances that enhance water resistance.
The main purpose of such a coating is to protect against the penetration of surface water and the appearance of leaks.
The composition has a number of advantages, among which it is worth noting:
- high level of adhesive strength
- resistance to negative and positive pressure of water masses
- versatility of application: applied to all types of stone surfaces, brick, aerated concrete, concrete and plaster
- you can apply the finish coating after 7 days
- easy to use: apply with a roller or with a spray gun
How to prepare a waterproofing mixture?
To prepare the working solution, mix the powder component with the liquid using a low-speed mixer at a speed of 500 revolutions per minute. Then let the solution stand for 3-4 minutes, then mix it again until a homogeneous mass is obtained.
For high-quality waterproofing, it is recommended to work out every corner with an insulating elastomeric tape with a polyester mesh Teknomer pah bandi.
On the cleaned moistened surface, Teknomer 200 EX Crystallized is applied in 2-3 layers with an interval of 3-6 hours. The total thickness of the coating should be about 3 mm.
What are the advantages of Teknomer 200 EX Crystallized waterproofing?
The advantage of the Teknomer 200 EX Crystallized mixture is also the fact that it is suitable for application on both vertical and horizontal surfaces. Thus, the composition is suitable for waterproofing walls in the bath. The application process is no different from applying to the floor: you can use a roller or a spray gun, covering the walls with waterproofing in 2-3 layers. Please note: during the day after application, it is necessary to protect the surface from direct sunlight, adverse atmospheric phenomena, high temperatures, precipitation, frost.
