Decorative plaster Teknodeko Cizgili(Coroid, 2 mm), 25 kg

Colour	White
Expiration date	12 months in the closed original packaging
Packaging	25 kg bag
Application temperature	+ 5 °C - + 35 °C
The ratio of the components of the compound	5,75 - 6,25 water / 25 kg powder
The size of the granules of the filler	3 mm (class S 4)
Vapor permeability	V1
Water resistance	W3
Fire resistance	A1

Consumption table:

Teknodeko Cizgili	Compound density (kg/l)	Consumption of powder per 1 m2 (kg)	Volume of water for mixing (l)
25 kg kraft bag	1,6	2,8-3,2	6,0-6,5

• Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting.
• If there are cracks or cavities on the surface they must be sealed with Teknorep cement compound.
• Before laying, the surface should be slightly moistened.
• When working in hot weather, it is recommended to use the Teknolatex 400 primer beforehand.
• Pour 5, 75 - 6.25 liters of clean cold water into a clean container. Slowly pour the powder Teknodeko Cizgili (25 kg) into a container with water and use a low-speed mixer to knead the composition for at least 10 minutes until a homogeneous mass is obtained. Leave the resulting compound for 5 minutes, then mix again. The amount of water required for mixing the compound depends on weather conditions.
• An equal amount of water should be used for each new batch of the compound. Otherwise, you can get a different shade.
• The finished compound should be applied within 2 hours, depending on weather conditions.
• Within 2 hours, the compound should be evenly applied to the surface with a steel spatula, removing excess material from the surface to obtain a layer of the required thickness. After that, a pattern should be made within 10 minutes. 
• The pattern is applied in circular movements using a plastic or polyurethane spatula to obtain a fine-grained texture.
• The material should be applied continuously to the surface to achieve a uniform layer.

Notes:

• Do not add water to the already mixed material.
• It is recommended to use a white primer before applying white decorative plaster.
• It is necessary to cover the surface with Teknodeko Cizgili plaster in 2 layers to increase resistance to external influences and contamination, as well as to prevent the production of a coating with different shades.
• The consumption of plaster depends on the pattern.
• The work should be carried out at an air temperature from + 5 °C to + 35 °C. When applying plaster at a reduced (below + 5 °C) or elevated (above + 35 °C) temperature, it is necessary to cover the surface with a thermal insulation material.
• The product may cause irritation if it gets on the skin. It is necessary to use work clothes, protective gloves, a mask and glasses. Before starting work, you can also apply a protective cream on your hands. In case of contact with the eyes, rinse the eyes immediately with warm water and consult a doctor.
• After applying the ocmpound for 12 hours, the surface should be protected from adverse weather conditions, such as direct sunlight, strong wind, high air temperature (more than + 35 °C), rain and frost.
• Paint can be applied to the surface, but not earlier than 7 days after applying the plaster. When applying dark paints, it is necessary to use a paint primer.
• The tools and equipment used must be washed with warm water immediately after use.