Many unskilled builders allow a complete fiasco when applying dry toppings, because working with them is a time-consuming process during which it is necessary to follow instructions and technologies, otherwise defects may occur that are difficult and expensive to fix.
Topping is distributed evenly over the entire surface. The most common violations are:
- non-compliance with the time frame of work
- neglect of the recommended material consumption per square meter.
Let's take a closer look at the process of working with concrete topping.
Stages of applying topping for concrete
It is recommended to distribute the topping evenly using a special dosing trolley. Since it is necessary to work with the hardener very quickly, it is not recommended to work manually, except on a very small area.
Concrete hardening by topping can be carried out in both 1 and 2 stages. In the second case, the first layer of topping is first rubbed (⅔ of the entire mass of the material), after which the remaining part (1⁄3) is distributed and rubbed with the second layer.
If you decide to harden the concrete surface with a dry hardener, you should not save on the material. Choose a high-quality topping, for example, Teknoser 100, a reliable manufacturer, such as Tekno, and follow all the recommendations, because it will be several times more expensive to redo later.
The last stage in working with dry toppings is protection from rapid moisture loss. To do this, it is recommended to apply Teknokur 100 curing, which prevents premature evaporation of moisture, thereby preventing the formation of cracks on the surface.
If you do not follow all these nuances, you will end up with a peeling of the topping.
What are the advantages of the Teknoser 100 hardener?
This material increases the strength properties of concrete by 1.5 times. It increases the durability of the surface, does not allow mechanical damage to form, makes it moisture-resistant, smooth and resistant to chemicals.
It is recommended to use topping for fresh concrete surfaces, which includes quartz filler, chemical and polymer additives, and a special paint pigment. All these components are available in Teknoser 100 topping.
Where can I use topping for concrete?
Topping for concrete is used for:
- parking lots and garages
- metro and underpasses
- industrial buildings and workshops
- warehouses, shopping centers.
Use Turkish-made Teknoser 100 topping to strengthen the concrete floor. The price and quality will please you.
