The repair compound Teknorep 300 EX(Текнореп 300 ЕХ)

Colour	Grey
Expiration date	12 months in a dry environment in a closed package.
Packaging	25 kg bag
Application temperature	+ 5 °C - + 35 °C
Mixing ratio	3.5-4.5 liters of water / 25 kg of powder
Viability	≥ 20 minutes
Commissioning	24 hours
Application thickness	10-40 mm (in one layer)
Flexural strength (EN 12808-3)	> 10.0 N/mm2
Adhesive strength with concrete (EN 1542)	> 2.0 N/mm2
Compressive strength (EN 12808-3)	> 60 N/mm2
Modulus of elasticity (EN 13412)	> 20 Gpa
Shrinkage (EN 12617-4)	> 2.0 N/mm2
Capillary water absorption (EN 13057)	< 0.5 kg/m2*h
Chlorine capacity	< 0,05%
Fire resistance	A1

Consumption table: 

Teknorep 300 EX	Density of the compound (kg/l)	Consumption of powder per 1 mm/1 m2 (kg)	Volume of water for mixing (l)
25 kg craft bag	2,06	1,8	3,5-4,5

• Before applying the material, the surface should be cleaned of any types of oil, rust, detergents, dirt and other substances that prevent setting.
• Before using Teknorep 300 EX, the surface should be moistened.
• To prepare the working solution, pour 3.5 - 4.5 liters of clean water into a clean container.  Pour the Teknorep 300 EX powder (25 kg) into a container with water and use a low-speed mixer to knead the composition for at least 5 minutes until a homogeneous mass is obtained. Leave the resulting compound for 3 minutes, then re-mix the compound for 2 minutes. Do not add water to the already prepared compound.
• The compound should be applied to the surface with a spatula. If necessary, apply a layer with a thickness of more than 40 mm, you should perform the work in several layers.
• When working on old concrete surfaces, you should first use the Tekno AD primer.
• When using Teknorep 300 EX in high wind conditions or other harsh environmental conditions, it is recommended to use Teknokur 100 as a curing material to prevent cracking of the surface.

Notes:

• For outdoor use,  it is necessary to protect the surface from moisture, sunlight and frost during the first 3 hours of solidification of the compound.
• When used at a low temperature, the lifetime of the compound increases, at an elevated temperature it decreases.
• When used in conditions of low temperature, it is necessary to use warm water, at high temperature – cold water.
• It is not recommended to use in contact with liquids whose pH value is lower than 5.5.
• Work should be carried out in compliance with safety and hygiene standards, using a mask and glasses.
• The tools and equipment used must be washed immediately after use.