Teknoplate (Текноплейт)

Surface quality, seams and joint surfaces must be dry and free from any kind of dust, dirt, loose and loose particles, grout residues, oil and grease. If present on weak concrete parts, they should be removed and the surface repaired with Teknogrout or Teknorep repair mortars.
The concrete base must be strong and have sufficient compressive strength (minimum 25 N/mm²) and a peel strength of at least 1.5 N/mm².
The side of Teknoplate to be bonded to the concrete should be rubbed with Tekno Tiner.
The prepared adhesive mixture is applied both to the concrete surface and to the tape with a spatula. Remains of glue should be removed immediately with a plastic roller with small teeth.
After the completion of the laying of carbon fibers, it is recommended to sprinkle with a thin layer of sand and apply plaster, because carbon fibers do not burn, however, the epoxy grout can catch fire at a certain temperature.
Notes:

• Clean tools and equipment with water immediately after use. Hardened material can only be removed mechanically.
• A structural reinforcement project should be designed and executed under the supervision of an experienced civil engineer.
• The product may cause irritation if it comes into contact with the skin. Work clothes, protective gloves, mask and goggles must be used. Before starting work, you can apply a protective cream on your hands. In case of contact with eyes, immediately rinse eyes with warm water and seek medical advice.

• Тех карта Teknoplate.docx__.docx