Teknowrap C (Текноуреп С)

Surface quality, seams and seams must be dry and free from any kind of dust, dirt, loose and loose particles, grout residues, oil and grease. If present on weak concrete parts, they should be removed and the surface repaired with Teknogrout or Teknorep repair mortars.
The concrete base must be strong and have sufficient compressive strength (minimum 25 N/mm²) and a peel strength of at least 1.5 N/mm².
First you need to prepare and cut the rope to the desired length with scissors or a clerical knife. After that, you should prepare Teknobond 300 epoxy glue, soak the rope with it and put it into the previously prepared seams.

Notes:

• A structural reinforcement project should be designed and executed under the supervision of an experienced civil engineer.
• Clean tools and equipment with water immediately after use. Hardened material can only be removed mechanically.
• The product may cause irritation if it comes into contact with the skin. Work clothes, protective gloves, mask and goggles must be used. Before starting work, you can apply a protective cream on your hands. In case of contact with eyes, immediately rinse eyes with warm water and seek medical advice.

• Тех карта Teknowrap C.docx__.docx