Epoxy primer Teknobond 350
Teknobond 350 is a two component epoxy primer water-based.
Teknobond 350 – two-component epoxy primer water-based.
Scope
- Indoors and outdoors
- Protective coating for industrial surfaces
- Shopping centers and supermarkets
- Parking lots and sidewalks
- Warehouses and factories
|
Color |
Transparent liquid |
|
The density of the components |
A: 1.08 kg/l ± 0,2%; B: 1.02 kg/l ± 0,2% |
|
The density of the mixture (A B) |
1.06 kg/l ± 0,2% |
|
Ignition temperature |
180°C |
|
Mixture proportions |
2 parts component A 1 part component B |
|
The pot life of the mixture |
45 minutes (at 20 °C) |
|
Full cure |
7 days |
|
Temperature resistance |
(-20 °C) - ( 60 °C) |
|
Packaging |
Set 15 kg |
|
Shelf life |
12 months in unopened original packaging |
Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks and cavities on surface should be repaired using convenient mixes Teknorep 300 and Teknorep 300EX.
Preparation of a mixture of: proportionally prepared with components A and B are mixed using a low shear mixer, use the mixing continued until a homogeneous consistency. Set TEKNOBOND 350 can be used in small quantities given the proportions of the mixture. Applying a mixture can be performed by brush, roller or spray. After application the surface should be protected from direct sunlight, strong wind and high air temperature (above 35° C).
Cleaning of the equipment. Immediately after application equipment must be cleaned with solvent Tekno.
Notes on application:
- For most high-quality curing of material, do not use the boundary temperature regimes. Low temperatures slow down the curing process, while higher temperatures accelerate the curing process. Viability will also vary depending on the temperature.
- If your mixture to the skin it should be washed with water with detergent. In case of contact with eyes, rinse with plenty lukewarm water and seek medical help.
