Waterproofing compound Teknomer 200(Текномер 200)

Consumption table:

• Before applying the material, the surface should be cleaned of any types of oil, rust, detergents, dirt and other substances that prevent setting.
• If there are cracks or other damages on the surface, they must be previously repaired with Teknorep repair solutions. Use Tekomer 200 3-4 days after surface repair.
• You should also determine the water pressure. Teknomer 200 is resistant to positive water pressure. If the water pressure is negative, do not use this waterproofing.
• On the surface to be tiled, you should work out every corner with the help of Teknomer pah bandi tape.
• Teknomer 200 should be applied to the surface with a brush or a spatula. Each next layer should be applied perpendicular to the previous one.
• The layer is considered dried when it ceases to be imprinted on the fingers.
• When applying waterproofing to the screed, it is necessary to use a waterproofing grid between the layers.
• To prepare the waterproofing compound, pour the liquid component B into a clean container, then slowly pour out the powdered component A. Using a low-speed mixer, knead the composition for 5 minutes until a homogeneous mass is obtained. Leave the resulting compound for 3 minutes, then re-mix the compound for 2 minutes.

Notes:

• Do not apply the compound on chipboard, MDF, plywood, PVC, wooden and metal surfaces.
• After applying the waterproofing make sure that direct sunlight and precipitation do not fall on the surface, and also do not use the material at temperatures above + 35 ˚С and below + 3 ˚С.
• After 3 days after applying the waterproofing, tiles or ceramics should be laid or plaster or screed should be applied to protect against all kinds of damage, scratches and bumps.
• Work should be carried out in compliance with safety and hygiene standards, using a mask and glasses.
• The tools and equipment used must be washed immediately after use.

1. Where is waterproofing performed?

Waterproofing is used to increase the water resistance of the surface. The waterproofing compound is applied to surfaces such as concrete, brick, plaster and screed.

2. What types of waterproofing are there?

Depending on the type of application, there are penetrating, coating, painting, pasting, injection waterproofing, etc. Depending on the type of water pressure, there are waterproofing compounds to make the surface resistant to positive water pressure and to negative one.

3. How do they make waterproofing in the bathroom?

Waterproofing of the bathroom can be done both with the help of ready-made acrylic mastic, and with the help of polymer cement. For example, for a bathroom, you can use a polymer-cement waterproofing compound Teknomer 200, which is considered a budget, but at the same time a sufficiently high-quality material. 

4. How to make waterproofing of walls?

In order to effectively waterproofing concrete walls, the material should be applied to cleaned and slightly moistened surfaces in 2 layers, while the second one should be applied perpendicular to the previous one. 

5. How to waterproof concrete?

There is a huge selection of various waterproofing materials in the plant chemistry market that need to be selected depending on the tasks and the type of surface. To choose the right waterproofing material, you can call the phone number: 0 800 307 050 and get a free consultation.