Paint for road markings Teknobond 960 white(Текнобонд 960)

• Before applying the material, clean the surface from any types of oil, rust, detergents, dirt and other substances that prevent setting. The recommended tensile strength is from 1.5 N/mm2.
• If there are cracks or voids on the concrete or asphalt surface, they should be repaired beforehand.
• The paint is applied in one layer, but if necessary, the application of the material in 2 layers - the second should be applied after 1 hour. It is applied with a brush, roller or a special device for marking road paint.
• If necessary, you can dilute the paint with Tekno solvent in an amount of 5-8 % by volume / weight of the paint and apply it using a mechanical sprayer. Between the layers, you need to pause for 15 minutes.

Notes:

• In no case should the paint penetrate into the sewers or drains.
• After partial use, the paint container must be tightly closed.
• Do not use paint in the rain.
• Do not dilute the paint with water.
• After applying the paint, the surface should be protected from adverse weather conditions, such as direct sunlight, strong wind, high air temperature (above 35 °C), rain and frost.
• The tools and equipment used should be cleaned immediately after use.