Waterproofing mixture Teknomer 110
One-component waterproofing material based on cement prevents the penetration of water.
Single component crystallized waterproofing material, cement based Teknomer 110. Applied gives the surface resistance to negative and positive water pressure. Included in the material composition insoluble crystals fill the pores of the concrete, preventing water penetration.
Applications:
- tunnels and lift shafts
- ground floors and basements
- showers and bathrooms
- pools, wells and water tanks
- reinforced concrete pipe
- large engineering structures
Advantages:
- penetrates deep into concrete and masonry base
- resistant to negative and positive water pressure
- can be applied manually or by spraying
|
Color |
Red |
|
Shelf life |
12 months in dry environment in unopened container |
|
Packaging |
20 kg bag |
|
Application temperature |
( 5 °C) - ( 35 °C) |
|
Mix ratio |
6-7 litres water / 25 kg powder |
|
The life time of the mixture |
20 min. |
|
Full cure |
5 days |
|
Water resistant |
7 Bar (positive and negative) |
Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks and cavities on surface should be repaired using the easy cement mixes Teknorep 300 and Teknorep 300 EX.
Before application the surface should be moistened. To mix the solution you must use a low speed electric mixer (max 400 rpm) for 5 minutes, then stand the mixture for 3 minutes and continue mixing until a homogeneous mixture. The application is performed by brush or spray. Then the prepared mixture is applied onto the surface 2-3 times with a brush. Can be applied with a stiff brush or by mechanical spraying.
Remarks / Restrictions:
- Do not use on surfaces made of wood, chipboard, MDF, plywood, PVC and metal.
- Use gloves, mask and goggles during work
- Use the recommended proportion for mixing
- The surface after application of the solution must be protected from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above 35 °C), rain and frost.
- Used tools and equipment must be cleaned with warm water immediately after use.
