Bitumastic Teknomer 400

Used for waterproof protection of building structures having contact with a damp environment.

Dmitry Pisansky

+380674864241

Description
Features
Instruction

A modified single component bitumen mastic Teknomer 400 solvent based with special additives. Applied for waterproof protection of building structures having contact with a damp environment. After curing on the surface of the coating forms a water resistant film layer.

Applications:

retaining walls and foundations
concrete terraced roof
the balconies and open terraces
galleries, drainage and drains, manifolds
open tanks and basins for water
protection of metal surfaces from corrosion

Advantages

completely ready to use
apply cold way
does not require heating and/or dilution
fast curing
creates a solid (seamless) insulation layer
can cover cracks
has high elasticity

Color	Black
Packaging	18 kg bucket
Shelf life	12 months in dry environment in unopened container
Dry mass residue	75 %
The softening temperature of	80 ° C
Application temperature	( 5 ° C) - ( 30 ° C)
The temperature resistance of the cured material	(-25 ° C) - ( 80 ° C)
Method of application	Brush, roller, sprayer
The curing time of the working layer	1 hour at 20 ° C
Complete drying of the working layer	24 hours at 20 ° C
Elongation to break	1000 %
Elasticity	90%

Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks, cavities on the surface - they must be repaired using the easy cement mixes Teknorep 300 and Teknorep 300 EX. The insulated surface must be dry and prepared. If, before applying TEKNOMER 400 dilatation of the design, it must first be insulated with tapes Teknomer Pah Band 120/70 and Teknobond 400 D.

Recommendations for the use of

Before application mix with low speed mixer until a homogeneous mixture. The mixing time is not less than 5 minutes. The material is ready for use and requires no dilution with water or other liquids. Do not apply under direct sunlight
Material ready-to-use, is applied to the surface with a wide brush or spray. Apply in two layers. The direction of deposition of each layer must be perpendicular to the previous one. The amount of time between coats for at least 1 hour. To increase adhesion between the layers, you can use fiberglass or reinforcing mesh.
After application protect surface from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above 35 ° C), rain and frost. Equipment immediately after use must be cleaned with a solvent.