Polymeric waterproofing Teknomer 700

Products > Waterproofing materials

Polymeric waterproofing Teknomer 700

One-component elastic waterproofing material with UV protection.


Введите свои данные

One-component elastic waterproofing material Teknomer 700 based on hybrid resins of the new generation, resistant to ultraviolet radiation. Maintains a constant elastic structure after application, quickly polimerizuet in conditions of high humidity.


  • terraces, roofs, balconies and gutters
  • foundations, walls, facades and roofs of buildings
  • protection from water and corrosion in concrete structures
  • waterproofing under tile materials
  • bitumen and asphalt surfaces


  • Resistant to UV radiation and chemicals
  • High adhesion to damp surfaces
  • Retains its elasticity even at low temperatures
  • Easy to apply (roller or brush)
  • Creates seamless coverage
  • It can be applied without the use of primer
  • Can be applied on the surface complex forms
  • Can contact with water



Density ( kg )

1.55 ± 0.05 kg/l

Shelf life

12 months in unopened original packaging


Bucket 1 kg, 14 kg

Full drying time

24 hours

The time between layers

8 hours


1.30 – 1.50 kg/m2

Application temperature

5 °C - 35 °C

Shore hardness (A)


Elongation to break

500 - 700 %

Operating temperature

-30 °C to 70 °C

Chemical resistance

Acidic and alkaline environment

Surface for application should be cleaned from any oils, rust, detergents and other substances that prevent adhesion. If there are areas in the form of cracks, cavities on the surface - they must be repaired using the easy cement mixes Teknorep 300 and Teknorep 300EX.

Material, ready-to-use, is applied to the surface with a wide brush or short-haired roller. Do not dilute, apply in two layers. The direction of deposition of each layer must be perpendicular to the previous one. The time interval between coats of at least 8 hours. As the gain between the layers, you can use fiberglass mesh.

Between the layers you want to use the optical fiber as the gain.

After application protect surface from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above 35°C), rain and frost until fully cured.

Immediately after application equipment must be cleaned with solvent.