Polyurethane waterproofing Teknomer 600 1K(Текномер 600 1K)

• Before applying the material, the surface should be cleaned of any types of oil, rust, detergents, dirt and other substances that prevent setting.
• If there are cracks or other damages on the surface, they must be previously repaired with Teknorep repair compounds. Use Tekomer 600 1K 3-4 days after surface repair.
• Before using Teknomer 600 1K, the joints should be worked with Teknomer pah bandi insulation tape.
• All gutters, drains and filters should also be insulated with Teknomer pah bandi.
• Next, apply the Teknobond 300 epoxy primer with a brush or roller with a flow rate of 0.200-0.400 kg/m². The consumption depends on the quality and absorbency of the concrete. You should wait until the primer dries (from 4 to 24 hours) and you can start applying Teknomer 600 1K.
• The material can be applied with a brush, roller or spray in several layers, and the second layer should be applied perpendicular to the previous one.  After applying the layer, you should wait at least 1 hour before applying the next one. The layer is considered dried when it ceases to be imprinted on the fingers.

Notes:

• After applying the primer, make sure that direct sunlight and precipitation do not fall on the surface, and also do not use the material at temperatures above + 35 ˚С and below + 3 ˚С.
• Since the material is not resistant to UV rays, after applying waterproofing, it is necessary to cover the surface with a finishing coating, such as tiles, plaster, screed, etc.
• Work should be carried out in compliance with safety and hygiene standards, using a mask and glasses.
• The tools and equipment used must be washed immediately after use.
• Do not apply Teknomer 600 1K in the rain.

• Тех карта Teknomer 600 1K.docx__.docx